VESA adapter for Lenovo

VESA adapter for Lenovo: the most important questions

Do you want to mount your Lenovo all-in-one PC on a monitor arm or the wall, but nothing fits on the back? You can find the right adapter for every tested Lenovo model here. Each one is built for specific models and attaches exactly where the stand normally snaps into place.

Why doesn't my Lenovo all-in-one PC have a VESA mount?

Some Lenovo all-in-one PCs are not designed for VESA mounting; they are only meant to stand on their own base. The adapter attaches in place of the stand and provides a hole pattern for your device.

How do I know which adapter my Lenovo all-in-one PC needs?

An all-in-one is significantly heavier than a monitor because the entire computer is inside the housing. Choose a mount with a load capacity that is sufficient for this.

Which mount can support an all-in-one PC?

One with a significantly higher load capacity than for a standard monitor: the entire computer is housed in the casing, so the device weighs several times more. Check the weight without the stand in the data sheet.

Which adapter fits my model?

The one where your full model number is listed in the model list. You can find this on the nameplate on the back. You can see the tested models for each adapter at the top and in the list below, or enter your model in the Setup Finder.

Do I need to drill or use adhesive?

No. The adapter attaches exactly where the stand normally sits and is fastened with the included screws. Everything is ready for your mount in about two minutes.

Will the adapter fit my mount?

Yes, provided your mount has the VESA hole pattern of the adapter, 75 × 75 or 100 × 100 mm. This applies to desk arms, wall mounts, and stands of any brand. If your mount requires a larger hole pattern, a VESA extension can bridge the difference.

Does an adapter hold my monitor securely?

Yes. The adapters are made of high-tensile plastics and metals that retain their shape for years. The mount determines how much weight is supported: its load capacity must be higher than the weight of your device without its stand.

Can I reattach the stand later?

Yes. Remove the adapter, reinsert the stand, and you're done. Because nothing is drilled, glued, or opened on the device, it remains in its original condition.

Don't have a mount yet? You can find every monitor mount here.

The adapter doesn't fit into the mount – what should I do?

Compare the full model number from the nameplate with the list on the adapter, including the suffix. Similar numbers often have different mountings. Never use force to insert the adapter.

The screws won't catch or are sitting crooked – what should I do?

Use the screws from the adapter bag, not the ones from the mount, and start them straight. Tighten them by hand first, then tighten them crosswise. If a screw does not catch, check whether it is too short or is hitting an edge before reaching the thread.

The monitor tilts forward on the mount – what should I do?

Tighten the tilt joint on the head of the mount. It is important that the weight of your device without the stand is within the load capacity of the mount; a heavier device exerts more pull on the joint.

The mount is not sitting flush against the adapter – what should I do?

Check if the back panel is curved or if cable connections are in the way. Spacers provide the necessary clearance.