VESA adapter for Philips

VESA Adapter for Philips: The most important questions

Do you want to attach your Philips monitor to a monitor arm or the wall, but nothing fits on the back? For every tested Philips model, you will find the right adapter here. Each one is built for specific models and attaches where the stand would otherwise snap into place.

Why does my Philips monitor not have a VESA mount?

Some Philips monitors are built too slim for a hole pattern; this also applies to some curved models. Often, there is a nearly identical version with VESA, but your specific one does not have a mount.

How do I know which adapter my Philips monitor needs?

The full model number is the deciding factor. Check it on the identification plate and compare it with the list on the adapter.

Which adapter fits my model?

The one where your full model number appears in the model list. It can be found on the identification plate on the back. You can see the tested models on each adapter above and in the list below, or you can enter your model in the Setup Finder.

Do I have to drill or glue?

No. The adapter uses the existing stand attachment: insert, screw on, done. The screws are included.

Will the adapter fit my mount?

Yes, if your mount has the VESA hole pattern of the adapter, 75 × 75 or 100 × 100 mm. This applies to desk arms, wall mounts, and stands of any brand. If your mount requires a larger hole pattern, a VESA extension compensates for the difference.

Will an adapter hold my monitor securely?

Yes. The adapters are made of high-tensile plastics and metals that maintain their shape for years. The mount determines how much weight is supported: its load capacity must be higher than the weight of your device without the stand.

Can I reattach the stand later?

Yes. Remove the adapter, insert the stand, done. Because nothing is drilled, glued, or opened on the device, it remains in its original condition.

Don't have a mount yet? You can find every monitor mount here.

The adapter does not fit into the mount – what should I do?

Compare the full model number from the identification plate with the list on the adapter, including the suffix. Similar numbers often have different mounts. Never force the adapter into place.

The screws do not grip or are sitting crooked – what should I do?

Use the screws from the adapter's bag, not those of the mount, and align them straight. Tighten them by hand first, then tighten them crosswise. If a screw does not grip, check if it is too short or if it is hitting an edge before reaching the thread.

The monitor tilts forward on the mount – what should I do?

Tighten the tilt joint on the head of the mount. It is important that the weight of your device without the stand is within the mount's load capacity; a heavier device pulls harder on the joint.

The mount does not lie flush against the adapter – what should I do?

Check if the back panel is curved or if cable connections are in the way. Spacers provide the necessary clearance.