VESA adapter for KOORUI

VESA adapter for KOORUI: the most important questions

Do you want to mount your KOORUI monitor to a monitor arm or wall, but nothing fits on the back? We have the right adapter for every tested KOORUI model. Each is built for specific models and attaches where the stand would otherwise click into place.

Why does my KOORUI monitor not have a VESA mount?

Some KOORUI monitors do not support VESA mounting according to the manual. The stand is inserted and clicks into place, and that is exactly where the adapter attaches. Other models from the brand have a standard hole pattern.

How do I know which adapter my KOORUI monitor needs?

Look under the stand or in the manual. If the four screw holes are missing, the adapter built for your model will fit.

Which adapter fits my model?

The one where your full model number appears in the model list. You can find it on the nameplate on the back. You can see the tested models for each adapter at the top and in the list below, or enter your model in our Setup Finder.

Do I need to drill or use adhesive?

No. The adapter uses the existing stand mount: insert, screw in, done. The screws are included.

Will the adapter fit my mount?

Yes, if your mount has the VESA hole pattern of the adapter, either 75x75 or 100x100 mm. This applies to desk arms, wall mounts, and stands of any brand. If your mount requires a larger hole pattern, a VESA extension will bridge the difference.

Will an adapter hold my monitor securely?

Yes. The adapters are made of high-tensile plastics and metals that hold their shape for years. The weight capacity is determined by your mount: its load capacity must be greater than the weight of your device without the stand.

Can I reattach the stand later?

Yes. Remove the adapter, insert the stand, and you're done. Because nothing on the device is drilled, glued, or opened, it remains in its original condition.

Don't have a mount yet? You can find every monitor mount here.

The adapter does not fit into the mount – what should I do?

Compare the full model number from the nameplate with the list on the adapter, including the suffix. Similar numbers often have different mounts. Never force the adapter into place.

The screws do not catch or are crooked – what should I do?

Use the screws from the adapter bag, not the ones from the mount, and insert them straight. Tighten them by hand first, then tighten them crosswise. If a screw does not catch, check if it is too short or hitting an edge before reaching the thread.

The monitor tilts forward on the mount – what should I do?

Tighten the tilt joint on the head of the mount. It is important that the weight of your device without the stand is within the load capacity of the mount; a heavier device pulls harder on the joint.

The mount does not sit flush against the adapter – what should I do?

Check if the back panel is curved or if cable connections are in the way. Spacers provide the necessary clearance.